Moisture Cured Floor Lacquer
Moisture Cured Floor Lacquer is a single-pack, clear glossy finish, moisture cured polyurethane floor coating that is quick-drying, chemical and abrasion resistant, providing high durability in moderately aggressive environments.Our Moisture Cured Floor Lacquer System is suitable for application onto concrete, timber, etc. for use in locations such as factories, warehouses, workshops, garages etc. with regular traffic, occasional spillages of chemicals, solvents, oils and other surface contamination.
- Fast Cure - Same day overcoating permits fast application, bring floors back into service quickly.
- Hard Wearing - Excellent resistance to pedestrian traffic, and moderate mechanical trafficking. Almost as good as a 2-pack floor coating, but faster drying.
- Chemical Resistant - Resists a wide range of chemicals and solvents providing excellent protection in many industrial environments.
- Oil & Grease Resistant - Ideal for factories, workshops and garages.
- Easy to use - Single pack product with no on-site mixing.
The slip-resistance of Moisture Cured Floor lacquer can be enhanced by applying our fine or medium grade anti-slip aggregate, scatter onto the wet first coat. This should be allowed to dry, then loose particles brushed away before applying the second coat to encapsulate the aggregate.
Ensure all areas are clean, sound, dry and free from all dust, dirt, loose and flaking material, and general surface contamination. All oils, grease and other contaminants, etc. should be removed with a suitable degreasing solution and/or steam cleaning. New concrete must be fully through-dry (a rule-of-thumb guide is to allow 1 month of drying time for every inch of concrete laid - For example 6 months for 6 inches of concrete). Etch or mechanically abrade any hard smooth, chemically treated or power floated concrete floors, and remove any surface laitance (soft under-bound surface layer). Timber surfaces should be thoroughly sanded and vacuumed.
Bare Porous or Friable Substrates: Apply 1 thinned coat (20% addition of Moisture Cured Thinners) of Moisture Cured Floor Lacquer. Apply 2 coats of Moisture Cured Floor Lacquer.
Previously lacquered substrates (sound): Existing lacquers must be sound, firmly adhered, properly prepared and suitable for coating (apply a test area if unsure). Remove all loose and flaking lacquer back to a tight area and 'feather' edges. Thoroughly abrade to roughen existing surfaces and remove sheen. Apply 1 thinned coat (20% addition of Moisture Cured Thinners) of Moisture Cured Floor Lacquer to bare areas. Apply 2 coats of Moisture Cured Floor Lacquer.
Theoretical coverage 10 square meters per litre. Practical coverage approximately 8 square meters per litre, this may vary depending on the porosity and profile of the substrate. Only apply by brush or short pile roller. Touch dry in approximately 3 hours. Hard dry 8 hours. Minimum overcoating interval: 8 hours. Maximum overcoating interval: 24 hours (it is important that each additional coat is applied within this time period to ensure a good chemical bond occurs between them). These times are based on a temperature of 20°C, normal relative humidity and good drying conditions. Do not apply if temperatures are below 10°C, especially in areas of low ventilation.
Available in clear glossy finish in 5 Litre sizes only.
| Price | |||
| Size | |||
| 5.00 litre | £55.98 | ||
| *prices include VAT | |||
SSL 
