Polyvine Stone and Brick Protector - Dead Flat

Polyvine Stone & Brick Protector is a non-reflective, modern water-borne acrylic coating which is absorbed into porous substrates, and dries to a dead flat finish. Use to seal, protect and decorate a wide range of interior and exterior substrates including stone, plaster, slate and brick on exposed walls and fire places, flagstones, stone window ledges etc.

Its natural non-reflective dead flat finish ensures you can seal and retain all the beauty of your exposed stone and brick surfaces. Offers excellent stain, water and chemical resistance. Polyvine Stone & Brick Protector is quick drying and particularly easy to use and apply.

Apply 2 coats of Polyvine Stone & Brick Protector to sound, prepared surfaces using a synthetic SRT paint brush. Mix well before and during use. On these types of porous substrates you should apply a priming coat of Polyvine Stone & Brick Protector thinned with 10% clean water to satisfy porosity and act as a sealer. When dry, thinly apply one further undiluted coat. Do not over apply.

Theoretical coverage 15-20 square meters per litre, this may vary depending on the porosity and profile of the substrate. Drying time approximately 15 minutes - 1 hour. Recoatable when dry. These times are based on a temperature of 20°C, normal relative humidity and good drying conditions. Over application will result in cloudy finish. Always test on a trial area before application to ensure you are satisfied with the result. Do not allow to pool in crevices (this will dry cloudy). Apply evenly do not allow to pool. Test for clarity over dark colours. Do not apply if air or substrate temperatures are below 10°C, especially in areas of low ventilation, and/or high humidity.

Polyvine Stone & Brick Protector is available in 1 litre and 4 litre sizes.

SizePrice
1 litre£14.40
4 litre£51.48

*all prices include VAT

As low as
£14.40
Polyvine Stone and Brick Protector - Dead Flat

Further information: