Water-based Epoxy Floor Paint - 2 Pack

Two-pack, semi-gloss finish, waterbased epoxy floor coating which combines very high durability, good resistance to chemicals, oil and grease with very low odour during application and curing.

For use as a floor paint in locations such as warehouses, food factories, canteens, kitchens, workshops, garages, showrooms etc. where solvent-based systems are not suitable.

  • Water-based - Solvent free and low odour making it ideal for hospitals, food manufacturers, kitchens, breweries, pharmaceutical areas etc.
  • High durability - Excellent resistance to abrasion, impact and general wear.
  • Oil & Grease Resistant - Ideally suited for use in workshops, garages etc.
  • Chemical resistant - Resists a wide range of chemicals and solvents, providing good protection in all environments.
  • Seamless & Easy Clean - Easy maintenance in hygenic and easy clean decontamination areas etc.
  • Slip resistant - High resistance to slipping and skidding provided by application of suitable grits into wet coating.

Ensure all areas are clean, sound, dry and free from all dust, dirt, loose and flaking material, and general surface contamination. All oils, grease and other contaminants, etc. should be removed with a suitable degreasing solution and/or steam cleaning. New concrete must be fully through-dry (a rule-of-thumb guide is to allow 1 month of drying time for every inch of concrete laid - For example 6 months for 6 inches of concrete). Etch or mechanically abrade any hard smooth, chemically treated or power floated concrete floors, and remove any surface laitance (soft under-bound surface layer).

Bare Concrete: Apply 1 coat Water-based Epoxy Binder Sealer, 2 coats Water-based Epoxy Floor Paint.
Previously painted substrates (sound): Wash, degrease and abrade to roughen surfaces and remove sheen. Apply 1 coat Water-based Epoxy Bonding Primer, 2 coats Water-based Epoxy Floor Paint.
Previously painted substrates (unsound): Remove all loose and flaking paint back to a 'tight' area and 'feather' edges. Apply 1 coat Water-based Epoxy Binder Sealer, 2 coats Water-based Epoxy Floor Paint.

The slip-resistance of Water-based Epoxy Floor Paint can be enhanced by applying our fine or medium grade anti-slip aggregate, scatter onto the wet first coat. This should be allowed to dry, then loose particles brushed away before applying the second coat to encapsulate the aggregate.

Theoretical coverage 10 square meters per litre. Practical coverage approximately 8 square meters per litre, this may vary depending on the porosity and profile of the substrate. Touch dry in approximately 6 hours. Minimum overcoating interval: 16 hours. Maximum overcoating interval: 72 hours (it is important that the second coat is applied within this time period to ensure a good chemical bond between the first and second coats occurs). These times are based on a temperature of 20°C, normal relative humidity and good drying conditions. Do not apply if temperatures are below 10°C, especially in areas of low ventilation.

Available in Grey, Light Grey (00A05) and Green as two components which when mixed together make 5.00 Litres. Please note that this is a 7 Kilo pack.

5 litre£121.09

*all prices include VAT