Trade Strip Paint and Varnish Remover is a unique patented water-based paint stripper based on dibasic esters. Trade Strip Paint and Varnish Remover has a slightly longer dwell time than more dangerous solvent based strippers based on Methylene Chloride (now banned), 1-methyl-2-pyrrolidone (NMP) & 1-ethyl-2-pyrrolidone (NEP) both of which are now classified as hazzardous reproductive toxins, and Benzyl Alcohol.

• Non Hazardous
• Non Toxic
• Non Caustic
• PH Neutral
• No Fumes
• No Skin Burn
• No Ventilation Required
• Non flammable
• Non combustible
• Suitable for use around people with respiratory problems such as asthma sufferers
• Working wet system - ideal for removal of lead-based paints
• No "R" (Risk) or "S" (Safety) phrases

Suitable for the removal of Lead-based paints, oil-based paints, solvent-based paints, water-based paints & emulsions, polyurethane's, wood stains, varnishes, waxes, intumescent paints, rust-preventative surface coatings.

Ideal for use on all types of surfaces including Wood (hard & soft), Marble, Stone, Brick, Concrete, Ceramic Tiles, UPVC, GRP, Aluminium, Brass and other soft metals

Trade Strip Paint and Varnish Remover allows the removal of up to 5 coats in one application. Clings 100% to vertical surfaces. No discolouration of timber, washes off with just water. Safely remove multiple layers of anti fouling and marine paints from Glass Fibre and GRP without affecting the gel coat. TradeStrip does not dry out after short periods of time, allowing large areas to be stripped successfully, unlike some solvent strippers which quickly evaporate.

Varnish, Shellacs, French Polish - 15-30 minutes
Under normal circumstances only one application required.

Lacquers, Polyurethane's - 30-45 minutes
2-3 applications may be required.

Anti Fouling Coatings, etc. from GRP - 30-45 minutes
2-3 applications may be required.

Multi-layered paint - 1 hour then scrape off.
Repeat process.

For more than 5-6 coats of paint (such as a door)
Apply liberally and leave for 1 hour and scrape off. Apply second coat and leave overnight.

To prevent drying out in hot conditions, or when left overnight we recommend that the treated area is covered with a plastic film.

Coverage: Approx 4-6 square meters per litre / per application. Instructions for use: Apply liberally on surface. Remove after required time with scraper, or ideally use stainless steel, or brass wire wool (see links on right hand side of page). Do not use steel wool as this will cause rust marks to penetrate into wooden surfaces. If required, apply a further liberal coat and repeat until bare surface is visible. Wash off any residue with a damp cloth or water. Use sandpaper to remove any small traces of finish, once the the surface has completely dried out.

Trade Strip Paint and Varnish Remover is available in 5 Litre & 15 Litre sizes.